This listing is for a Made-To-Order of Warlock bond foam kit. The DIY kit needed to be assembled, sealed and painted. The kit consist of 1pc of primary bond, 11pcs of smaller pieces, 1pc of the acrylic part. Various LED color are available. For “Finished” finishing, please note in the order on what is your primary and secondary color.
Measure the bond to your arm size, cut to size and glue the ends together. Glue the smaller pieces to the primary bond. Seal and paint the kit. Guide the acrylic part’s wire connector to the bond center. Attached them together. It might be tight. If its loose, apply some hot glue.
Assembly guideline : http://www.instructables.com/id/Destiny-Warlock-Bond-Kit-Assembly/
Diameter of the bond : 13cm
Height of the bond : 6cm
Disclaimer : Please read the shop policies before purchasing. This is a fan based item and made with just references floating around. Any copyright reserved to its respective owner.There will be slight differences between the pictures and the item you will received due to the camera/monitor setting and each one of them are individually made.
2019 @ ShiroppiDIY.com
Twitter : www.twitter.com/shiroppidiy
Facebook : www.facebook.com/shiroppidiy
Instagram : www.instagram.com/shiroppidiy